Visualizza wikitesto di Selection of optimal process parameters for wire arc additive manufacturing



'''Authors''': Mariacira Liberini, Antonello Astarita, Gianni Campatelli, Antonio Scippa, Filippo Montevecchi, Giuseppe Venturini, Massimo Durante, Luca Boccarusso, Fabrizio Memola Capece Minutolo, A. Squillace

'''Keywords''': Wire arc additive manufacturing; ER70S-6 Steel; Microstructure; Vickers hardness.

'''Purpose''':  the purpose is to define the effect of process parameters on the final microstructure of the product obtained in order to choose the optimal setup. The process parameters varied within the tests has been chosen in order to vary both the heat input of the process and the heat flux in a specific product area.

'''Design/methodology/approach''': The test samples were made by depositing successive layers of materials on a low carbon steel substrate. The filler material used is a standard filler for welding structural steels: ER70S-6 designation according AWS legislation. The test samples were made by superimposing 15 layers. A pause of 60s was imposed between each layer deposition, in order to enable a partial cooling of the deposited material. In the execution of the specimens it was maintained a distance of 10 mm between the torch and the work surface. All the samples are cooled in calm air at room temperature.
 
'''Findings''': in all the samples have been noted three different zones: the lower zone characterized by a ferritic structure with thin strips of pearlite, the middle zones characterized by equiaxed grains of ferrite and the upper zone characterized by a lamellar structure typically bainitic. 

'''Practical implications''': it’s possible to obtain a structure ferrite/bainite according to the needs required by the final product.

'''Full reference''': LIBERINI, Mariacira, et al. Selection of optimal process parameters for wire arc additive manufacturing. Procedia Cirp, 2017, 62: 470-474.

'''Link''': [http://www.sciencedirect.com/science/article/pii/S2212827117301968 www.sciencedirect.com/science/article/pii/S2212827117301968]
[[File:Microstructure of the samples.png|miniatura]]